Vermont Natural Coatings Penetrating Waterproofer Infused with Juniper qt

Unleash the protective prowess of Juniper, meticulously infused into our Vermont Natural Coatings Water Proofer, forging a fortress against moisture with zero VOCs. This groundbreaking formula not only seals but stabilizes wood from within, extending its lifespan by curbing moisture, mold, and decay. Embrace the natural evolution of wood hues, as our Penetrating Water Proofer leaves no topcoat, allowing its innate beauty to shine. With a commitment to sustainability and performance, redefine wood preservation with this eco-friendly solution. Application: If new wood, be certain surface is thoroughly cleaned before applying. For pressure washing, do not exceed 1200 psi and use wide-spray nozzle. Allow to dry completely. For previously coated material, be sure all loose finish is removed, then clean thoroughly. Test to ensure wood is able to accept finish by checking if water beads on surface, or soaks into wood. If water soaks in, the wood it is able to accept Penetrating Water Proofer. Stir well prior to use. Apply with a brush and/or spray equipment without thinning to a properly prepared surface. Brush in any puddles of product on the surface. Apply two coats. The second coat must be applied before the first coat dries. If the first coat fully dries it will not allow the second coat to penetrate. No sanding is required between coats. Coat all wood surfaces and end-grain and apply in temperatures between 45° – 100°F and relative humidity of 40%-60%. Coating all surfaces increases the stability of the wood. High humidity or low temperature may lengthen dry time. DRYING/CURING: Under normal conditions, surface will be ready for foot traffic in 2-3 hours after second coat. One gallon will cover approximately 300 sq. ft. depending on porosity of wood.