Vermont Natural Coatings Dynaseal Concrete & Masonry Sealer gal

Discover the cutting-edge innovation of Dynaseal Concrete & Masonry Sealer by Vermont Natural Coatings. Harnessing revolutionary nanoparticle technology, this sealer creates a flexible, non-film forming, breathable barrier that penetrates deep beneath the surface, safeguarding against water damage and decay. Serving as both a sealer, waterproofer, and primer, Dynaseal offers unparalleled protection with just a single coat, ensuring years of durability. With Dynaseal, embrace a new era of surface protection that prioritizes longevity and sustainability, revolutionizing the way you preserve your concrete and masonry surfaces. Surface should be free of dust, dirt, contaminants, oil, grease or additives. Clean surfaces thoroughly with Vermont Natural Coatings Multi-Surface Cleaner before applying Dynaseal Concrete & Masonry Sealer. Can be used as a primer for Vermont Natural Coatings PolyRock Concrete Coating. Can be painted over when dry to touch. APPLICATION: 1) Stir or shake well prior to use. 2) Always test finish on a discrete area to confirm desired appearance. For best results apply when relative humidity is between 40% to 60%. Do not apply if temperature is below 35?F/1.67?C. 3) Apply with a brush, painters pad, pump-up garden sprayer, air-assisted and/or airless sprayer. Use 17 to 19 tip and medium to coarse spray pattern. Brush out any puddles. 4) Apply one coat. If applying two coats or when using tints and two coats are required, apply second coat when first coat is still damp. Do not sand between coats. On very porous concrete or masonry an additional coat may be necessary. 5) Under normal conditions treated concrete will be dry and ready for foot traffic in 2-3 hours. One Gallon will cover approximately 200-300 sq. ft.